We do not currently support the idea that control surface support needs to be scriptable in a non-compiled language. Going via JACK will not work for Ardour users who do not use JACK (Ardour has not needed JACK for several years). I am appreciating your input! How would you do it? Can I set an active channel in Ardour by MIDI messages? Do I need the LUA scripting? On the Ardour side, I hope a MIDI binding map would be enough. It would remember the “state”, light up LEDs to reflect the state and translate MIDI commands based on the state. My current plan is to write a JACK client that acts as a proxy. I am a programmer, know C++ and a little C and would also be comfortable with the LUA scripting of Ardour if necessary. I am focusing on Linux/JACK and ideally it should work with any DAW. The Launch Control XL sends MIDI note commands for all of its buttons/faders/knobs except for the 2 template buttons. I got inspirated by Jürgen Moßgrabers integration of the APC40 into Bitwig where he switches between different layouts with the help of a controller script for Bitwig (as I understand, that is not possible with Ardour): I do not have a Pitch wheel so far, so I want a knob to act as one on a different JACK Midi out.select a track and control a selected synth plugin without the need for manual remapping.record arm for tracks (the whole “select action, then channel”-functionality the device is built for).Out of the box ( ) channel volumes and solo/mute work. I don’t know where this will be going and am seeking your feedback. I don’t want to accept that it is not possible, but rather write a software that enables its full potential. I am starting a new thread on this subject: This is actually about Integrating MIDI Controllers/Scripting/Extending Ardour. Hello Ardour community! Thank you for this wonderful software, I appreciate its functionality, nice manual and the open-minded philosophy.
0 Comments
Leave a Reply. |